Cement Equipment

Main purposes:
HBSH Three Cylinder Dryer is used to dry particle materials within a certain range and humidity, such as the mortar dry yellow sand used by industry, all specification sand used in foundry industry, building materials used in cement industry blast furnace slag, and small particle size clay, used in the chemical industry can not afford to chemical changes, is not afraid of high temperature and small particles of dust soiled materials. According to different materials industry demands, after drying, the humidity content reach less 1-0.5%. It is good if the materials that come into the dryer not stick the plate and Yang plate. The temperature that into the dryer is not higher than 750 degrees Celsius, if having the special requirements for high-temperature drying, at the entrance of inside the dryer drum and Yang plate can be made by heat-resistant steel plate.Second, the main features:
1.Three-cylinder dryer have the features of compact structure, covering less area that is half for single cylinder dryer that have same volume.
2. Working reliable, low energy consumption and high thermal efficiency, high drying materials effect, and easily to implement automated control, needing less operators.
3. Equipment investment required is 6/1 than the same imported products.
4. The last humility of material will be ensured less 0.5%, that is the first choose products for slag powder production line.
5. The keeping heart efficiency of self-cylinder up to above 80% (traditional single-dryer thermal efficiency is only 35%) that have improve the thermal efficiency 45%.
6. The fuel can be adapted to coal, oil, steam and could dry the following block, pellet, powder materials that less 20mm.
7.It could less 50% area than the single drier, and the construction investment will low 50%, power consumption less than 60%.
8. It could be easily adjusted the last water indicators according to the user requirements.
9. The temperature for exhausting air is not high, long service life of removal dust equipment.
10. No need the large and small gear rotation, using the wheel rotating.
11. The material temperature is below 60%, can be production packaged continuously.